Працюючи кроки міні яєчного інкубатора:
1 Unpack the box and check the incubator, and check whether all of the accessories inside of the packing box are well-equipped, including top cover, base, automatic egg tray, mesh plate, instruction and power cord.
2 Before use, remove the top cover on the incubator, there are movable egg tray bracket and egg tray mesh inside the base, in order to prevent damage during the transportation, the base, movable egg tray bracket and egg tray mesh are tied up during package, please disassemble it before use.
3 Take movable egg tray bracket and egg tray mesh out of the base. Wash and clean the base, feed water to tank A and B inside of base, then put the movable egg tray bracket into the base.
4 After covering the top cover, rightly connect the power line and switch on the power supply, if temperature is indicated on the control panel in normal condition, the heating indicator(Work) will be on incubator will begin to heat up.
5 Note: when ambient temperature is less than 25°C, measure shall be taken for heat preservation, it’s good for temperature uniformity when the device is enclosed with clothes or other warms, and it also helps energy-saving and reduces heat dissipation.
6 Check all parameters according to Push-button instruction.
7 The motor on egg tray shall be connected to the joint in top cover, so that the motor is available for 24-h work without interruption (the motor will work as long as the device is powered on).
8 After the power and switch are on, the switch indicator on panel turns to red and it will send alarm if the temperature shows “L” and the alarm can be released by pushing “SET”, “+” and “-” . The incubator can be put into running after 2 hours’ trial
9 Check whether all the display meter are as in normal, and it well start to record time by pushing the time reset button after the breeding egg is placed.
10 It will start to record the number of days after pushing the time reset button.
11 It’s about to incubate, put the selected eggs well and the bigger side shall be up, take down the incubation time.
12 The incubator begins to incubate, pay attention to the temperature indicated on the control panel, adjust it in time if it doesn’t comply with requirement, check the water level for every 2-3 days so as to avoid incubator in lack of water.
13 It will send alarm if the humidity is lower than 45%, so please do remember to add water. There are only display and alarm function for humidity,
14 After incubation for 18-19days (take egg as example), the egg tray shall be exchanged, firstly, take the egg off from movable egg tray bracket after the power is cut off, and take egg tray out of the incubator after the motor’s joint is taken off, put the egg tray mesh into the incubator, and lay one layer of egg on the egg tray mesh, then wait for the young poult to break the shell and come out.
15 The egg tray exchange time is different according to number of incubation days of kinds of poultry, it usually takes 3-4days less than the number of incubation days. It’s also the time to exchange the egg tray when one or two eggs breaks.
16 Pay attention to temperature and relative humidity adjustment during the whole incubation process, refer to incubation Technology in the operation instruction for more details.